Dear Kenwood Customer:

Thank you for your e-mail.  This is simple directions for programming your TM-G707A.......

1. Push the VFO button
2. Enter your desired frequency
3. Push the TONE button until the T shows in the display for repeaters with PL/Encode
4. Push F button then SHIFT to select your + or - offset
5. Push the F button, then push the T. SEL button, at this time the PL/Encode number will
   appear (example 88.5 will be flashing) turn the main tuning knob to select the desired
   PL/Encode.
6. Now to store the PL press the OK button (which is the far right button on the bottom)
   (This is the set of the four little button that all look the SAME) 
7. To store all this information into Memory, push the F button, and when the memory numbers 
   appear to the right of the frequency display turn the main tuning knob to the desired 
   Memory of your choice, push the MR button to store the information.
8. To recall that memory just push MR again. 
    


If you need further assistance, please e-mail us again.

Sincerely,
Kenwood Amateur Radio Customer Support