Dear Kenwood Customer:

Thank You for your e-mail. TM-D700A quick start programming.......

1. Press the left volume control to a VHF, now Press the VFO button enter the frequency
   example(146.670 MHz). 
2. Now to select the offset press the F button, and then press the SHIFT button, It will
   change from + to - to simplex every time you press that sequence. On 2 meters is has a
   automatic offset selector due the 2 meter band plan in the U.S. I does not have 
   this feature on 440 MHz.
3. Now to select a PL/Tone/Encode, please press the TONE button, now a T will show in the 
   top  of the display. Now press the F button and then the T.SEL button. The PL/Tone will
   appear in the display flashing. Now turn the main tuning knob to your desired PL/Tone
   example 97.4, now to store that PL/Tone press the OK button on the far right side. The
   display will go back to its original state showing the frequency you entered earlier.
4. Now you may store all this information in memory. First press the F button, and on the
   right side of the display you will see a memory number FLASHING,  and a arrow facing 
   the right turn the main tuning knob and select your desired memory. You may now store 
   the frequency with all the information by pressing the M.IN button. To recall that memory 
   selection please press the MR button.


If you need further assistance, please e-mail us again.

Sincerely,

Kenwood Amateur Radio Customer Support