DTMF Pad tester
This will only support reading back one DTMF button at a time. To make it read back DTMF in CW press "#8" listen to the message. Then after the message press any one digit per transmission and it will read it back.

To make the DTMF read back in voice just press "*"+ the number or letter you want it to read back. Example "*9" will say 9 or "*A" will say Alpha.
REMOTE BASE COMMANDS
Please allow one second of key time before you enter any command.
Turn the remote base on enter: "*B1"
To Receive only enter: "##"
To Transmit enter: "#*"
Turn the remote base off enter: "#B"
Using the memory channels on the remote base
First before you try to QSY the remote base make sure it is not in transmit mode. Give your ID & press "##" to put it in receive mode before you do anything. This way if it is linked up your giving your final ID on what it is linked to.
Also note that it will not transmit on the 220 band. But it can receive there.
To switch between memory channels enter "B" plus the three digit memory channel number.
Example: "B056" will put the radio on memory channel 056 the chart below shows this is 146.580.
Example: "B122" will put the radio on memory channel 122 the chart below shows this is 443.975.
When changing between memory channels you will hear a quick burst of tones. This is the computer talking to the link radio. Also it lets you know that your command was entered.
Memory channel list

Copyright © 2002 Justin Priami. ( This site is best viewed at 1024 x 768 resolution )
All Rights Reserved. Images on this website may not be put as part of ANY collection without prior written permission. Pages by KG4CEO