what the SX-28 documentation consists of? I have just started a restoration project for an Hallicrafters SX-28 (no 'A', no 'MIL'). I have found on http://bama.sbc.edu/ the following manuals: "Operating Alignment and servicing instructions for the 1941 super skyrider model sx-28" under the sx-28 link and "Instruction book for Model SX-28 super skyrider receiver" under the sx-28mil link. The question is: is this the only documentation available? Does any body know if other manuals exist? And where? Thank you very much ciao =============== wich caps use when recapping I have just started a restoration project for an Hallicrafters SX-28 (no 'A', no 'MIL'). I am about to recap it almost interely. Questions: wich "modern" capacitors have to be used to replace old tubulars? I am now able to find vertical mount caps a mere speck and with the same electrical charateristics.... Is it ok to use them? what about mica caps? What about trimmers caps? And what about electrolytics (again, I can get same charateristics on very very small caps..) Thank you very much ciao ================== mica compression trim caps I have just started a restoration project for an Hallicrafters SX-28 (no 'A', no 'MIL'). In the bill of material of my SX-28 I have found 6 trimmer caps with the following description: "XXXX mmfd.(nominal) variable mica compression" where XXXX is a number. The alignment procedure clearly states not to adjust them! I have also found them in the chassis: they look like very robust trimer caps... Question: How can I check those items? What probability I have got that they are leaky? What about if somebodyelse has alredy turned them someway? Thank you very much ciao ================ SX-28 output transformer I have just started a restoration project for an Hallicrafters SX-28 (no 'A', no 'MIL'). Unfortunately the output transformer is not original. The rig has been handled bymany people and I am trying to get rid of all the mods introduced... Any suggestion on how to replace it (other than getting a new one from the various BA sources)? Can I find a way to convert the radio to work with an 8 ohms loudspeaker? (this is in contrast with my objective to restore the radio as it was,... but no money is left for an original 5000 ohms speaker :=) ) Thank you very much ciao