INTERNATIONAL SPACE
STATION
There are quite a few programs to monitor the packet transmissions from the international space station ( AFSK 1200 ) the uiss program is a dedicated program for the space station, thou any AFSK 1200 program will be fine
See my note regarding the agw program - this is what you will see if its not enabled / installed correctly
To control your transmitter too will need an interface of some kind for ptt / audio out from the computer to the tcvr microphone / audio into the computer sound card. You could make one yourself check my circuit’s page out
IMAGES CAPUTURED IN REAL TIME
FROM THE ISS
for some images from the recent space walk click this lnk
A good sstv program for sstv transmissions from the space station can be downloaded from
http://www.qsl.net/on6mu/uissabout.htm
The frequency used for transmissions is 145.800 mhz
The mode is usually pd120 - below is a screen shot from the program - pc only won't run on a raspberry pi
For a raspberry pi sstv program see the official qsstv download site
telemetry from the international space station
following the link here
or have a look at a sample of the telemetry ( obviously out of date now ) below
sample telemetry from the space station - probably easier to just look at the 'live' site
what
radio frquencies are used by the
international space station ham radio operators ? check this site |
what
antenna is required ? - i built a crossed dipole
which i use and it seems to work ok |
uiss
packet program - http://www.qsl.net/on6mu/uissabout.htm |
trutty - download from here - it has a afsk
1200 packet radio facility |
agw
packet engine - download from here |
wxtrack - so you know when to listen |
gpredict - so you know when to listen |
gpredict
ver 2.2.1 - easy install on rpi 3 |
|
* important - for the uiss packet program to run you need to have the agw program running first, the link to the agw software is a few years old but it works and the version of agw there is free whereas i think that the new version of agw has to be paid for *
RASPBERRY PI
GQRX will only run on a raspberry pi - GPREDICT has a windows version as well as a version of software for the raspberry pi
Above is a screen shot of GQRX
The above is a screen shot of GPREDICT which will show you where all the satellites are - NOAA wx satellites, space station etc
compiling gpredict
on the raspberry pi |
gpredict
ver 2.2.1 - easy install on rpi 3 |
gqrx has a afsk 1200 packet de-modulator on it
- make sure you put the right version on theres a
difference between rpi 2 & rpi
3 ! |
multimon ng - will decode pager
signals and afsk1200 plus numerous other protocol |
le site est encore en construction - mais tous les liens travailleront