Working with single memories

You can use two different way's to edit or delete memories in your memory banks.

The first way is to use FT100-SuperControl� to edit or delete memories in your memory banks. Simply go to the pulldownmenu "Edit -> MEM" and choose wich database you would like to edit or delete.

(Picture 1.1 - edit standard memories)

(Picture 1.2 - edit satellite and dualband memories)

(Picture 1.3 - edit HF-, VHF- and UHF- repeater memories)

(Picture 1.4 - edit logbook-memories)

(Picture 1.5 - edit skedbook-memories)

(Picture 1.6 - edit special memories with DCS, DEC, ENC, AZ und EL)

To edit the entry's, simply overwrite the text in the textboxes ! To save your previously edited entry, simply use the button "save record".

The textbox "skip" is needed for the memory scanner (refer to chapter 2 - Memory functions). A value of "0" means, that this memory should be scanned, a value of "1" means, that this memory should not be scanned with the scanner.

Legend:

ADD = add a memory to the database

SAVE RECORD = save the previously edited memory to the database

DELETE = delete memory entry from the database

READ AGAIN = read again the shown memory

CLOSE = close / exit the editor window

Edit or delete memories with the use of Microsoft Access�:

If you have experience with Microsoft Access�, you are able to use this program to edit or delete entry's from the FT100-SuperControl� databases. Attention: Please don't use MS Access 2000� or higher, because these newer versions will change the structure of the databases. FT100-SuperControl� will then no longer be able to access these changed databases. Please use always MS Access 95� or MS Access 97� only ! If you need further information on how to work with Microsoft Access�, please refer to the users manual for this program.