System - requirements

Minimum system-requirements:

• 486 or Pentium I - processor
   

• 800x600 graphics display setting
   

• system: Windows9x / WindowsME / Windows2000 / WindowsNT4 / WindowsXP
   

• serial interface cable (YAESU CT-62)
   

• free serial port with a speed of 4800 baud (COM1 to COM8)

Recommended system-requirements:

• Pentium II-350 � processor or higher
   

• 1024x768 graphics display setting
   

• system: Windows9x / WindowsME / Windows2000 / WindowsNT4 / WindowsXP
   

• 16-bit soundcard
   

• additional cable between soundcard and your FT-100 (phoneplugs 3,5mm)
  (a better solution would probably be a real soundcard interface)
   

• serial interface cable (YAESU CT-62)
   

• free serial port with a speed of 4800 baud (COM1 to COM8)
  
  
   

Support for additional software:

• NOVA� satellite-tracker (used for doppler-calculation)
  You can download a limited version at http://www.nlsa.com/

• WinOrbit� satellite-tracker (not yet fully supported)
   

• WISP� satellite-tracker (not yet fully supported)
   

• ARS� satellite-tracker (not yet fully supported)
   

• STATION� satellite-tracker (not yet fully supported)
   

• ARS-Interface software (Rotator control)
  You can download a free version at: http://www.ea4tx.com

Support for additional hardware:

• FT100-SuperControl� is designed to support up to two transverter-devices. One for each antenna jack in the rear of the FT-100 transceiver (HF / 6m � UHF / VHF).
   

• EasyComm rotator interface or other EasyComm capable hardware
  

• ARS-Interface for the parallel port (Rotator control)
  You can order the interface at: http://www.ea4tx.com