Re: [SI-LIST] : Shielded Flat Flex Cable

About this list Date view Thread view Subject view Author view

From: Bill Owsley ([email protected])
Date: Wed Feb 28 2001 - 14:39:51 PST


For prototypes of one or two, we used to cover with copper tape and pigtail
it to the one or two ground pins of the connector... greatly illuminating
! We knew we onto something... ;^>

At 01:53 PM 02/28/2001 -0800, Rod Barman wrote:

>I apologize in advance for this being off topic, but I'm looking
>for a source of shielded flat flex cable in prototype quantities.
>
>In particular I would like to find 0.5mm, 15 conductor, 6 inch,
>shielded although anything close would be great.
>
>The only source I've been able to find is Digikey but they no longer
>carry shielded flex cable.
>
>I also understand that I could in theory paint the cable with
>a conductive coating.
>
>Thanks --rod.
>
>**** To unsubscribe from si-list or si-list-digest: send e-mail to
>[email protected]. In the BODY of message put: UNSUBSCRIBE
>si-list or UNSUBSCRIBE si-list-digest, for more help, put HELP.
>si-list archives are accessible at http://www.qsl.net/wb6tpu
>****

----------------------------
Bill Owsley, [email protected]
919) 392-8341

Compliance Engineer
Cisco Systems
7025 Kit Creek Road
POB 14987
RTP. NC. 27709

**** To unsubscribe from si-list or si-list-digest: send e-mail to
[email protected]. In the BODY of message put: UNSUBSCRIBE
si-list or UNSUBSCRIBE si-list-digest, for more help, put HELP.
si-list archives are accessible at http://www.qsl.net/wb6tpu
****


About this list Date view Thread view Subject view Author view

This archive was generated by hypermail 2b29 : Tue May 08 2001 - 14:30:59 PDT