Re: [SI-LIST] : Problems with XNS

About this list Date view Thread view Subject view Author view

From: polus@lexmark.com
Date: Wed Jan 24 2001 - 06:19:56 PST


In an experience a few months ago, we literaly had a small piece of trace
touching another trace in the artwork. We don't know how it happened, fot in the
previous spin of the card, everything was cool. You may actually have 2 traces
shorted somewhere in your stackup.

Harold Polus
Lexmark Laser Printer Controller Development

subramanya.murthy%wipro.com@interlock.lexmark.com on 01/24/2001 08:38:54 AM

Please respond to subramanya.murthy%wipro.com@interlock.lexmark.com

To: si-list%silab.eng.sun.com@interlock.lexmark.com
cc: (bcc: Harold Polus/Lex/Lexmark)
Subject: [SI-LIST] : Problems with XNS

CKS StationeryHello all,
I'm using View Logic's XNS for the post-route simulation of my boards. And
facing a peculiar problem.
I'm getting an error message while trying to run the xfx command to generate
Transmission line Parameter (.tlp) file .
The error message is : " conductors <num> and <num> are touching in CONFIG
<num> "
I tried commenting this particular configuration in the .xfx file. But
this lead me to errors at a later stage (while building the database for
analysis in XNS).
Is there anybody out there who faced the same problem with their design ? if
yes, what's the remedy ?

Thanks in Advance
Subramanya

Subramanya C K
Embedded Systems & Internet Access Solutions Group
Wipro Technologies
+91-80-852-0408 (EXT. 4179)
subramanya.murthy@wipro.com



**** To unsubscribe from si-list or si-list-digest: send e-mail to
majordomo@silab.eng.sun.com. In the BODY of message put: UNSUBSCRIBE
si-list or UNSUBSCRIBE si-list-digest, for more help, put HELP.
si-list archives are accessible at http://www.qsl.net/wb6tpu
****


About this list Date view Thread view Subject view Author view

This archive was generated by hypermail 2b29 : Tue May 08 2001 - 14:30:43 PDT