From: subramanya C K ([email protected])
Date: Wed Jan 24 2001 - 05:38:54 PST
CKS StationeryHello all,
I'm using View Logic's XNS for the post-route simulation of my boards. And
facing a peculiar problem.
I'm getting an error message while trying to run the xfx command to generate
Transmission line Parameter (.tlp) file .
The error message is : " conductors <num> and <num> are touching in CONFIG
I tried commenting this particular configuration in the .xfx file. But
this lead me to errors at a later stage (while building the database for
analysis in XNS).
Is there anybody out there who faced the same problem with their design ? if
yes, what's the remedy ?
Thanks in Advance
Subramanya C K
Embedded Systems & Internet Access Solutions Group
+91-80-852-0408 (EXT. 4179)
**** To unsubscribe from si-list or si-list-digest: send e-mail to
[email protected] In the BODY of message put: UNSUBSCRIBE
si-list or UNSUBSCRIBE si-list-digest, for more help, put HELP.
si-list archives are accessible at http://www.qsl.net/wb6tpu
This archive was generated by hypermail 2b29 : Tue May 08 2001 - 14:30:43 PDT