From: Scott McMorrow ([email protected])
Date: Tue Jan 16 2001 - 22:36:04 PST
Doug,
The model is incorrectly extracted. The rfixture should have
been 50 ohms.
scott
Doug Hopperstad wrote:
> I have a question regarding the IBIS model format. Within the model there
> R_Fixture. I understand that the R_fixture was used to create the rise and
> fall time charts. My question is the value of the resistor. Is there a
> relationship of the resistor to a load resistor that would be used in the
> lab? The information below came from a SSTL-2 output model.
>
> Vref = 1.250V
> Rref = 0.125k
> Cref = 10pF
> Vmeas = 1.250V
>
> [Rising Waveform]
> R_fixture = 0.125k
> V_fixture = 1.250
> V_fixture_min = 1.250
> V_fixture_max = 1.250
>
> R_load = 0.125k
>
> How come the resistor value does not reflect a more typical 50 ohm
> application?
>
> Doug Hopperstad
>
> **** To unsubscribe from si-list or si-list-digest: send e-mail to
> [email protected]. In the BODY of message put: UNSUBSCRIBE
> si-list or UNSUBSCRIBE si-list-digest, for more help, put HELP.
> si-list archives are accessible at http://www.qsl.net/wb6tpu
> ****
-- Scott McMorrow Principal Engineer SiQual, Signal Quality Engineering 18735 SW Boones Ferry Road Tualatin, OR 97062-3090 (503) 885-1231 http://www.siqual.com**** To unsubscribe from si-list or si-list-digest: send e-mail to [email protected]. In the BODY of message put: UNSUBSCRIBE si-list or UNSUBSCRIBE si-list-digest, for more help, put HELP. si-list archives are accessible at http://www.qsl.net/wb6tpu ****
This archive was generated by hypermail 2b29 : Tue May 08 2001 - 14:30:38 PDT