[SI-LIST] : SMA test connector PCB layout

About this list Date view Thread view Subject view Author view

From: Larry Miller ([email protected])
Date: Wed Jan 03 2001 - 05:38:32 PST


I need to make some measurements on PC boards up to 5 GHz using a network
analyzer. In the past I didn't care that much because I was doing TDR
measurements.

Unfortunately, the boards I will be looking at are too thick to use the "SMA
edge connector" trick.

Does anyone have a pointer to a good PCB footprint that will not have
impedance discontinuities. The connector I want to mount is the familiar
center pin + 4 ground pins vertical SMA style.

Thanks in advance for any help,

Larry Miller

**** To unsubscribe from si-list or si-list-digest: send e-mail to
[email protected]. In the BODY of message put: UNSUBSCRIBE
si-list or UNSUBSCRIBE si-list-digest, for more help, put HELP.
si-list archives are accessible at http://www.qsl.net/wb6tpu
****


About this list Date view Thread view Subject view Author view

This archive was generated by hypermail 2b29 : Tue May 08 2001 - 14:30:32 PDT