Re: [SI-LIST] : 200 ohms

From: Bill Owsley ([email protected])
Date: Fri Dec 01 2000 - 11:34:09 PST

• Next message: Zabinski, Patrick J.: "RE: [SI-LIST] : Why can a resistor can reduce noise in output buffer"
• Previous message: Ingraham, Andrew: "RE: [SI-LIST] : 200 ohms"
• In reply to: Sean Murray: "[SI-LIST] : 200 ohms"
• Next in thread: GARY ROSEN: "Re: [SI-LIST] : 200 ohms"

what's your stackup and dielectric ?
If Dk = 3, trace is about 13-14 mils, microstrip - so the highly calibrated
SWAG software says. ps. this is it's limit of guessability.

At 11:02 AM 12/01/2000 -0700, Sean Murray wrote:
>Anyone able to achieve 200 ohms on .250 thick board before? If not what is
>the closest achievable board impedance within reason?
>
>Sean Murray
>General Manager
>
>M&M Specialties, Inc.
>1236 W. Southern Ave. #106
>Tempe, AZ 85282
>1-800-892-8760 x105
>
>www.mmspec.com
>
>
>
>**** To unsubscribe from si-list or si-list-digest: send e-mail to
>[email protected]. In the BODY of message put: UNSUBSCRIBE
>si-list or UNSUBSCRIBE si-list-digest, for more help, put HELP.
>si-list archives are accessible at http://www.qsl.net/wb6tpu
>****

----------------------------
Bill Owsley, [email protected]
919) 392-8341

Compliance Engineer
Cisco Systems
7025 Kit Creek Road
POB 14987
RTP. NC. 27709

**** To unsubscribe from si-list or si-list-digest: send e-mail to
[email protected]. In the BODY of message put: UNSUBSCRIBE
si-list or UNSUBSCRIBE si-list-digest, for more help, put HELP.
si-list archives are accessible at http://www.qsl.net/wb6tpu
****

• Next message: Zabinski, Patrick J.: "RE: [SI-LIST] : Why can a resistor can reduce noise in output buffer"
• Previous message: Ingraham, Andrew: "RE: [SI-LIST] : 200 ohms"
• In reply to: Sean Murray: "[SI-LIST] : 200 ohms"
• Next in thread: GARY ROSEN: "Re: [SI-LIST] : 200 ohms"

This archive was generated by hypermail 2b29 : Tue May 08 2001 - 14:30:20 PDT