[SI-LIST] : RF Via Advice?

About this list Date view Thread view Subject view Author view

From: Bradley S Henson ([email protected])
Date: Mon Nov 27 2000 - 06:51:53 PST


SI and Board Experts:

I've asked our route folks to use "RF vias" for our 1Gbs fibre channel
signals in our PWBs, where we must use vias. My definition of RF vias, from
the literature, is that the pad is omitted from the signal via on power and
ground layers to reduce capacitance. I also asked for larger than normal
clearances to the planes, assuming no signals routing through the area. The
product design folks have responded by saying there could be a reliability
problem (thermal cycling induced barrel cracking) if they omit the pads
from the internal power and ground layers on my FC signal vias. I'm only
proposing a couple of RF vias in a PWB with 1000's of conventional vias.
Could these few vias really cause a problem? Anyone have any experience
with this? BTW, our boards are typically 14 layer dual offset stripline and
use 4 mil polyimide dielectric layers (fairly lossey, but useable for short
runs). I don't know the via aspect ratio...I'm trying to find out.

Thanks,
Brad Henson, Raytheon

**** To unsubscribe from si-list or si-list-digest: send e-mail to
[email protected]. In the BODY of message put: UNSUBSCRIBE
si-list or UNSUBSCRIBE si-list-digest, for more help, put HELP.
si-list archives are accessible at http://www.qsl.net/wb6tpu
****


About this list Date view Thread view Subject view Author view

This archive was generated by hypermail 2b29 : Tue May 08 2001 - 14:30:15 PDT