From: Aloke Bhattacharya ([email protected])
Date: Fri Nov 10 2000 - 21:32:49 PST
Hello all,
I had a doubt regarding plane splits:
In the stackup, if there is a power plane on one side of the signal
layer and a ground plane on the other side of the signal layer(symmetric
stripline config), and if the ground plane is a solid ground plane
having no discontinuities, then can I have splits in the power plane and
run traces over the splits? Is the ground plane alone not sufficient to
provide paths for return currents?
With regards,
Aloke
**** To unsubscribe from si-list or si-list-digest: send e-mail to
[email protected]. In the BODY of message put: UNSUBSCRIBE
si-list or UNSUBSCRIBE si-list-digest, for more help, put HELP.
si-list archives are accessible at http://www.qsl.net/wb6tpu
****
This archive was generated by hypermail 2b29 : Tue May 08 2001 - 14:30:05 PDT