From: George Rasko ([email protected])
Date: Fri Nov 10 2000 - 15:27:18 PST
I was wondering if there was anyone who had experienced problems
with differential signalling when one implementation transitions to
another. For example, assume the target is 100 ohms differential.
The backplane implements an edge coupled pair with individual trace
to ground impedance of 70 ohms and 100 ohms diff, but the daughter
card implements two traces with 50 ohms to ground on opposite sides
of the the ground plane (once again, 100 ohms diff), is this a signal
quality problem waiting to happen?
George
**** To unsubscribe from si-list or si-list-digest: send e-mail to
[email protected]. In the BODY of message put: UNSUBSCRIBE
si-list or UNSUBSCRIBE si-list-digest, for more help, put HELP.
si-list archives are accessible at http://www.qsl.net/wb6tpu
****
This archive was generated by hypermail 2b29 : Tue May 08 2001 - 14:30:04 PDT