Re: [SI-LIST] : Parallel single-ended traces routed to achieve 35 Ohm controlledimpedance

About this list Date view Thread view Subject view Author view

From: Michael Nudelman ([email protected])
Date: Fri Oct 27 2000 - 13:10:31 PDT


E-r-r-r....Any particular reason for doing this exercize?

[email protected] wrote:

> Has any one tried to achieve controlled impedance for a single-ended trace by
> running two traces in parallel?
>
> ==================== GND PLANE
> DIELECTRIC THICKNESS T1
> +-----+
> |/////| SINGLE TRACE 70 OHMS
> +-----+
>
> DIELECTRIC THICKNESS T2 (T2>T1)
>
> ==================== GND PLANE
>
> +-----+
> |/////| SINGLE TRACE 70 OHMS
> +-----+
>
> ==================== GND PLANE
>
> Using this trace geometry, if each trace is 70 Ohms relative to its reference
> planes, and I tie them together at the ends, will this yield 35 Ohms or
> something a little less than half Zo of each trace?
>
> Thanks,
> -- §al Aguinaga Jr.
> -- 3Com - Carrier Business Networks
> -- Mt. Prospect, IL
>
> **** To unsubscribe from si-list or si-list-digest: send e-mail to
> [email protected]. In the BODY of message put: UNSUBSCRIBE
> si-list or UNSUBSCRIBE si-list-digest, for more help, put HELP.
> si-list archives are accessible at http://www.qsl.net/wb6tpu
> ****

**** To unsubscribe from si-list or si-list-digest: send e-mail to
[email protected]. In the BODY of message put: UNSUBSCRIBE
si-list or UNSUBSCRIBE si-list-digest, for more help, put HELP.
si-list archives are accessible at http://www.qsl.net/wb6tpu
****


About this list Date view Thread view Subject view Author view

This archive was generated by hypermail 2b29 : Tue May 08 2001 - 14:29:51 PDT