[SI-LIST] : BLVDS Hot Swap

About this list Date view Thread view Subject view Author view

From: Steve Ash ([email protected])
Date: Fri Apr 07 2000 - 14:56:10 PDT


Does anybody out there have any data on pre-charging BLVDS (multipoint LVDS)
signal lines in a HOT SWAP application for the purpose of preventing the
glitch that could occur when the BLVDS lines are momentarily shorted by the
card being hot-plugged. I'm thinking that this may be required but I have
not seen any mention of it with respect to BLVDS. What is the recommended
method of doing this?

Somebody out there must be hot plugging BLVDS devices.

Thanks,

Stephen Ash
Senior Hardware Designer
Sedona Networks
10A Hearst Way
Kanata, Ontario
K2L 2P4

Tel: (613) 599-1600 ext. 5062
Fax: (613) 599-3040
Mailto:[email protected]

**** To unsubscribe from si-list or si-list-digest: send e-mail to [email protected]. In the BODY of message put: UNSUBSCRIBE si-list or UNSUBSCRIBE si-list-digest, for more help, put HELP.
si-list archives are accessible at http://www.qsl.net/wb6tpu
****


About this list Date view Thread view Subject view Author view

This archive was generated by hypermail 2b29 : Thu Apr 20 2000 - 11:36:05 PDT