From: [email protected]
Date: Wed Nov 03 1999 - 14:43:48 PST
Nice to hear from you.
Your comments re: the low impedance effects are right on the mark. And, it
is very difficult to get accurate measurements of the milliohm levels the BC
For physically large, higher current systems, one approach I have found
effective is to partition different sections of the PCB using power plane
moating techniques. This technique must be used by knowledgeable designers
who check for all critical current return paths, as well as all other normal
SI and EMC considerations. Most smaller boards perform well without such
surgery, but increasing clock speeds are forcing the issue harder and harder.
Michael L. Conn
*** Serving Your Needs with Technical Excellence ***
**** To unsubscribe from si-list: send e-mail to [email protected] In the BODY of message put: UNSUBSCRIBE si-list, for more help, put HELP. si-list archives are accessible at http://www.qsl.net/wb6tpu/si-list ****
This archive was generated by hypermail 2b29 : Tue Feb 29 2000 - 11:39:34 PST