[SI-LIST] : XTK multiboard simulation using amp spice connector models....... ..

About this list Date view Thread view Subject view Author view

From: Greim, Michael ([email protected])
Date: Wed Dec 01 1999 - 13:52:20 PST


Hello SI List,

        I am continuing my investigation of XTK and have run into
a bit of a road block that I thought you might be able to help me with.
I have a desire to perform a multi-board system simulation where my
board to board interconnect is a standard 2 mm HM connector that
is used and supported by lots of folks. I have an AMP MLM for the
connector and would prefer not to fill my day modifying spice decks.
My feedback from folks to date has been that 'ya can't get there from
here', unless of course I would like to re-write the model myself for
use within XTK.

        I know that alot of folks in telecom are using this connector
and are probably using XTK. What are my options? Any good?
Thanks for the help.

Best Regards,

Michael Greim

And all this science they don't understand
It's just my job six days a week.....

The time is gone, The email's over, thought I'd
something more to say.........

Michael C. Greim Consulting Engineer
Mercury Computer Systems, Inc email: [email protected]
199 Riverneck Road V: 978-256-0052/x1607
Chelmsford, MA 01824-2820 F: 978-256-4778

**** To unsubscribe from si-list: send e-mail to [email protected]. In the BODY of message put: UNSUBSCRIBE si-list, for more help, put HELP.
si-list archives are accessible at http://www.qsl.net/wb6tpu/si-list
****


About this list Date view Thread view Subject view Author view

This archive was generated by hypermail 2b29 : Tue Feb 29 2000 - 11:39:03 PST