Re: [SI-LIST] : IBIS models

Dan Bostan (dan@uniant.com)
Thu, 26 Aug 1999 14:30:20 -0500

I even go one step further : if I have an alternative, I do not design
around a component that can not be satisfactorily simulated ( for the lack
of a good model, for example...).
So, in other words, I use the power of the $ leverage.

Dan Bostan
Engineer
Corvia Networks e-mail: dan@corvia.com
212 Gibraltar Dr. ph: 408.752.0550/x111
Sunnyvale, CA 94089 fax: 408.752.0551

----- Original Message -----
From: Kim Helliwell <khelliwe@acuson.com>
To: <si-list@silab.eng.sun.com>
Sent: Thursday, August 26, 1999 3:10 PM
Subject: Re: [SI-LIST] : IBIS models

> Yep! TI's the one, but I wasn't going to say so!
>
> At least, TI gives you a model for each type of pin;
> some vendors don't even do that much. I recently saw
> a model that only gave the output buffer model, but
> no input buffer model (even though there were input
> pins).
>
> But you're right: we should gripe the manufacturers about
> these bad modeling practices.
>
>
>
> Mike Mayer wrote:
> >
> > Thanks for the replies to the IBIS [Pin] question. The manufacturer in
> > question is TI. I have let them know that the IBIS spec requires them
> > to specify every pin. Although I am grateful for the fact that there
> > is a model available at all, I also feel that unless I speak up about
> > the shortcomings of models the situation will never improve.
> >
> > --
> >
============================================================================
=
> > Mike Mayer Artesyn Communication Products,
Inc
> > Madison, WI
> > http://www.artesyn.com/cp
> >
============================================================================
=
> >
> > **** To unsubscribe from si-list: send e-mail to
majordomo@silab.eng.sun.com. In the BODY of message put: UNSUBSCRIBE
si-list, for more help, put HELP. si-list archives are accessible at
http://www.qsl.net/wb6tpu/si-list ****
>
> --
> Kim Helliwell
> Senior CAE Engineer
> Acuson Corporation
> Phone: 650 694 5030 FAX: 650 943 7260
>
> **** To unsubscribe from si-list: send e-mail to
majordomo@silab.eng.sun.com. In the BODY of message put: UNSUBSCRIBE
si-list, for more help, put HELP. si-list archives are accessible at
http://www.qsl.net/wb6tpu/si-list ****
>
>

**** To unsubscribe from si-list: send e-mail to majordomo@silab.eng.sun.com. In the BODY of message put: UNSUBSCRIBE si-list, for more help, put HELP. si-list archives are accessible at http://www.qsl.net/wb6tpu/si-list ****