However, the 3D tool, XFX3D is flaky and can give
impossible or unlikely results, such as 0 (self)
inductance for a round connector pin, which was
part of a larger connector structure. That's assuming
it completes the simulation prior to crashing...
Has anyone in- or out-side of Viewlogic experienced
getting good results from XFX3D?
Regards,
-- Laurence
Do not add me to any mailing lists. Not speaking for GDC.
**** To unsubscribe from si-list: send e-mail to [email protected]. In the BODY of message put: UNSUBSCRIBE si-list, for more help, put HELP. si-list archives are accessible at http://www.qsl.net/wb6tpu/si-list ****