Re: [SI-LIST] : Transmission line inductance
Fred Balistreri ([email protected])
Thu, 25 Mar 1999 10:39:06 -0800
Josip Popovic wrote:
>
> I would like to now if anyone of you had to create a PCB trace with a
> precise inductance value?
>
> In the spec for LT1533 (Linear Technology switching regulator) is shown
> that
> the device should have 25nH inductance between the ground pin and the
> PCB
> GND. According to my calculations a microstrip line with W=7 (H=5, T=2.8
> and
> Er=4.3) has app. 6.5nH/inch. So to get a 25nH trace one would need to
> have a
> 3.8inch long trace.
>
> Q1: Is there a trace configuration that I could use to create a 25nH
> inductance that would not be so lengthy and in the same time would not
> act
> as an antenna?
>
> Q2: Is my calculation (app 6.5nH/inch) correct?
>
> Josip
>
> **** To unsubscribe from si-list: send e-mail to [email protected]. In the BODY of message put: UNSUBSCRIBE si-list, for more help, put HELP. si-list archives are accessible at
Based on your numbers I get 7.88nh/inch.
Best Regards,
--
Fred Balistreri
[email protected]
http://www.apsimtech.com
**** To unsubscribe from si-list: send e-mail to [email protected]. In the BODY of message put: UNSUBSCRIBE si-list, for more help, put HELP. si-list archives are accessible at http://www.qsl.net/wb6tpu/si-list ****