[SI-LIST] : semi-rgid cable

From: [email protected]
Date: Tue May 08 2001 - 07:26:09 PDT

• Next message: Rich Peyton: "[SI-LIST] : Standards"
• Previous message: Shoaib: "[SI-LIST] : 480MHz differntial pair on USB2.0"
• Next in thread: Raymond W. Waugh: "Re: [SI-LIST] : semi-rgid cable"
• Maybe reply: Raymond W. Waugh: "Re: [SI-LIST] : semi-rgid cable"

Hello si-list,

I have a question concerning semi-rigid cable. How does one prepare the cable
for connector attachement?
Currently we use a turning lathe (I hope this is correct translation: in dutch
draaibank) to strip the outer
copper. However, we can only use this for short cable lengths (about 10cm).

What are the available techniques and tools? Is it possible to build these tools
and operate them
manually? Or do you recommend to buy prepared semi-rigid cables.

Regards,

Jan Vercammen
Agfa-Gevaert NV

**** To unsubscribe from si-list or si-list-digest: send e-mail to
[email protected]. In the BODY of message put: UNSUBSCRIBE
si-list or UNSUBSCRIBE si-list-digest, for more help, put HELP.
si-list archives are accessible at http://www.qsl.net/wb6tpu
****

• Next message: Rich Peyton: "[SI-LIST] : Standards"
• Previous message: Shoaib: "[SI-LIST] : 480MHz differntial pair on USB2.0"
• Next in thread: Raymond W. Waugh: "Re: [SI-LIST] : semi-rgid cable"
• Maybe reply: Raymond W. Waugh: "Re: [SI-LIST] : semi-rgid cable"

This archive was generated by hypermail 2b29 : Thu Jun 21 2001 - 10:11:51 PDT