From: Ingraham, Andrew (Andrew.Ingraham@compaq.com)
Date: Thu Apr 19 2001 - 10:40:42 PDT
> >By the way, I often setup DC biasing that switches off shortly
> >after the transient simulation begins. This way I don't have
> >to wait for transients to settle out.
> how do i do this ? is this set in the sim. tool ? if yes then
> how do i do this in cadence?
If you were using SPICE, you can use .IC statements. These effectively
connect voltage sources to the nodes you specify, which are turned on only
during the initial transient solution (t=0) and disconnected immediately
after. You may also need to specify "UIC" in the .TRAN statement. (SPICE
explanations of how UIC and .IC and IC= affect simulations are never very
clear, and I am not sure whether all SPICE versions go by the same rules.)
Sorry, don't know how to do this in Cadence.
**** To unsubscribe from si-list or si-list-digest: send e-mail to
firstname.lastname@example.org. In the BODY of message put: UNSUBSCRIBE
si-list or UNSUBSCRIBE si-list-digest, for more help, put HELP.
si-list archives are accessible at http://www.qsl.net/wb6tpu
This archive was generated by hypermail 2b29 : Thu Jun 21 2001 - 10:11:40 PDT