From: [email protected]
Date: Mon Apr 02 2001 - 06:46:54 PDT
If you are running differential signals between to racks through a
shielded cable, what should you do with the cable drains?
Hard wire both-ends to the chassis?
Hard wire one end and let the other float?
Float both ends?
Connect through a series resistor, or series cap, or series cap and
resistor in parallel?
Is there a rule of thumb or formula based on something to help you
determine how to connect the shielding?
I have seen it done several different ways but never have been real sure
which way is correct.
Thanks,
Stacy
**** To unsubscribe from si-list or si-list-digest: send e-mail to
[email protected]. In the BODY of message put: UNSUBSCRIBE
si-list or UNSUBSCRIBE si-list-digest, for more help, put HELP.
si-list archives are accessible at http://www.qsl.net/wb6tpu
****
This archive was generated by hypermail 2b29 : Thu Jun 21 2001 - 10:11:23 PDT