We made a change to the repeater that will allow you to determine (by the reset beep) which receiver you are getting into on the repeater. N9CX has designed a microcontroller circuit that should allow this to be done reliably. There will be four different reset beeps as follows: 1. High frequency (1200 Hz) CW "M" indicates the last transmission was in the Main receiver at least 88% of the time. 2. High frequency (1200 Hz) CW "R" indicates the last transmission was in the Remote receiver at least 88% of the time. 3. Low frequency (500 Hz) CW "M" indicates the last transmission was in the Main receiver a majority (but less than 88%) of the time. 4. Low frequency (500 Hz) CW "R" indicates the last transmission was in the Remote receiver a majority (but less than 88%) of the time. For the Repeater Committee, Dave - K8RSP
return to the top of the page.