224.940 / 444.150 (100HZ Tone) Repeater/Remote Base
Repeater/Remote Command List (Most Commonly Used): 
Command__________________________DTMF entry
Select Memory Channel:______________CB58 (this selects mem 58, or 146.58.. Enter B and the desired memory number, then unkey)
VFO Freq Entry:____________________CD14*275D (example is to enter 14.275 MHz)Step Freq UP 1 KHz:____________C2
Step Freq DOWN 1 KHZ:_____________C1
Select/Toggle through Modes:__________C8
Read Back Current Mode:_____________C0 (Zero)
Read Current Freq in CW:_____________C4
Activate Remote Base transmit_________587
Remote Base Receive Only: ___________576
Toggle RX Preamp:__________________C5
Toggle RX 20dB Attenuator:___________C3
Select 80/40M Dipole________________*1A
Select Triband(10-15-20-6M) Beam ____*1B
Select Ringo Ranger 2M vert ant_______*2A
Select 2M + 432 horiz beams__________*2B
Scan Start _________________________CA (MUST be in monitor-only mode (576) to scan, Starts from current freq)
Scan Stop _________________________PTT