which you may see in some of the pictures
This is shot of project start with bottom cover removed
The cover seems under sized and stuck on
I removed two ribon cables & the hold down screws to stand the IF board up right
No big guns here. A very small pencil solding iron - perhaps with temp control even
The 220 ohm resistor in place
small print - this is not a design page - this shows the installation of a NB mod
from the w8ji web page.
The data for results
http://www.w8ji.com/receiver_tests.htm
============================================================
W5AJ HOME PAGE
TOP 50
This page added 2003 Dec