Re: [SI-LIST] : High speed board to board connection

From: Jon Keeble (jkeeble@alpha.net.au)
Date: Mon May 28 2001 - 06:04:41 PDT

• Next message: Jason Leung: "Re: [SI-LIST] : Antenna Problem on the Board"
• Previous message: Wang Xiao-yun: "Re: [SI-LIST] : On chip decoupling"
• In reply to: Andrew W. Riley III: "Re: [SI-LIST] : High speed board to board connection"
• Next in thread: Mike Saunders: "Re: [SI-LIST] : High speed board to board connection"
• Reply: Mike Saunders: "Re: [SI-LIST] : High speed board to board connection"

I've used these Mictor connectors successfully.
I chose them because they mate with a Tektronics Logic Analyser lead set.
The PCB mounting connector comes in two parts - the connector and a shroud.
The shroud requires a couple of mounting holes, and provides for mechanical
stability for the lead set.

Jon Keeble

----- Original Message -----
From: "Andrew W. Riley III" <drewmeister3@earthlink.net>
To: "Shahar Eytan" <shahar@mellanox.co.il>; <si-list@silab.eng.sun.com>

> Moving the motherboard can cause the connectors to
> separate just enough to create problems with design verification. I
> even observed the senior engineer having problems without moving the
> motherboard

**** To unsubscribe from si-list or si-list-digest: send e-mail to
majordomo@silab.eng.sun.com. In the BODY of message put: UNSUBSCRIBE
si-list or UNSUBSCRIBE si-list-digest, for more help, put HELP.
si-list archives are accessible at http://www.qsl.net/wb6tpu
****

• Next message: Jason Leung: "Re: [SI-LIST] : Antenna Problem on the Board"
• Previous message: Wang Xiao-yun: "Re: [SI-LIST] : On chip decoupling"
• In reply to: Andrew W. Riley III: "Re: [SI-LIST] : High speed board to board connection"
• Next in thread: Mike Saunders: "Re: [SI-LIST] : High speed board to board connection"
• Reply: Mike Saunders: "Re: [SI-LIST] : High speed board to board connection"

This archive was generated by hypermail 2b29 : Thu Jun 21 2001 - 10:12:09 PDT