[SI-LIST] : edge card connector suggestions?

From: Zabinski, Patrick J. ([email protected])
Date: Thu May 24 2001 - 13:19:51 PDT

• Next message: abe riazi: "RE: [SI-LIST] : Frequency based on rise time for drivers"
• Previous message: Hassan Ali: "[SI-LIST] : Board stackup"

I need to interface two 0.062" cards, edge-to-edge (co-planar),
with signals around 200 MHz. I need to get 240 (or more)
contacts within ~2.5 inches of board-edge (implying ~20 mil
contact pitch on two surfaces). I also need to keep the
height of the connector(s) within 50 mils from the board surface.

Any suggestions?

Pat

**** To unsubscribe from si-list or si-list-digest: send e-mail to
[email protected]. In the BODY of message put: UNSUBSCRIBE
si-list or UNSUBSCRIBE si-list-digest, for more help, put HELP.
si-list archives are accessible at http://www.qsl.net/wb6tpu
****

• Next message: abe riazi: "RE: [SI-LIST] : Frequency based on rise time for drivers"
• Previous message: Hassan Ali: "[SI-LIST] : Board stackup"

This archive was generated by hypermail 2b29 : Thu Jun 21 2001 - 10:12:07 PDT