Re: [SI-LIST] : SpecctraQuest v Hyperlynx

About this list Date view Thread view Subject view Author view

From: Carlos Moll ([email protected])
Date: Fri May 11 2001 - 06:19:50 PDT


David:

 From a non-biased point of view...

If you were to compare your requirements related to bit pattern error
detection or ISI, comprehensive waveform editing capabilities, differential
support, coupling of connectors/package ball I/O's, mutli board and package
to board ,etc. system level simulations , then you should at a minimum be
looking at a comparison between SpecctraQuest and XTK, not Hyperlynx.

 From a biased point of view...

If you use Capture and Allegro as your standardized flow, then the
SpecctraQuest integration to your flow will provide you with the most
powerful and comprehensive SI solution!!

If you need me to further elaborate on such differentiations and why , then
you can email me directly at [email protected].

Carlos Moll
Cadence Design Systems

   At 10:15 AM 5/11/2001 +0100, David Instone wrote:
Dear Group,
   In addition to all the 'normal' things the above are used for, given
the need to simulate differential pcb traces and the connectors,drivers
and receivers associated with them at rates upto 4 gigabaud, which of
the above would you prefer to use?

I also want to be able to display the resulting eye pattern and/or
calculated the resulting DJ from Inter Symbol Interference (ISI).
Naturally I would want to be able to read in board designs (we use
Cadence/allegro for pcb layout and Orcad for schematics) and it would
be nice if it would run 'stand alone' on a Labtop while on-the-road.

-- 
Regards

Dave Instone. Compliance Engineer Storage Systems Development, MP24/22 Xyratex, Langstone Rd., Havant, Hampshire, P09 1SA, UK. Tel: +44 (0)23-92-496862 (direct line) Fax: +44 (0)23-92-496014 http://www.xyratex.com Tel: +44 (0)23-92-496000

**** To unsubscribe from si-list or si-list-digest: send e-mail to [email protected]. In the BODY of message put: UNSUBSCRIBE si-list or UNSUBSCRIBE si-list-digest, for more help, put HELP. si-list archives are accessible at http://www.qsl.net/wb6tpu ****

**** To unsubscribe from si-list or si-list-digest: send e-mail to [email protected]. In the BODY of message put: UNSUBSCRIBE si-list or UNSUBSCRIBE si-list-digest, for more help, put HELP. si-list archives are accessible at http://www.qsl.net/wb6tpu ****


About this list Date view Thread view Subject view Author view

This archive was generated by hypermail 2b29 : Thu Jun 21 2001 - 10:11:55 PDT