From: Westbrook, Scott ([email protected])
Date: Wed May 02 2001 - 14:13:56 PDT
The XTK in the ePD 1.1.1 release (available now for about a month) will allow you to use a Spice model as a series model for your parallel rlc ciruit. You could try that.
Scott Westbrook...
Network Appliance
-----Original Message-----
From: [email protected] [mailto:[email protected]]
Sent: Thursday, April 26, 2001 5:09 PM
To: [email protected]
Subject: [SI-LIST] : [SI-LIST] parallel rlc modeling in XTK
Hi everyone,
I have a simple question about modeling device R,L,C are conencted in parallel in XTK.
For example,
(Driver) ---- (Device) ---- (Receiver)
Equivalent circuit of above Device is as follow:
------ Resistor ------
| |
------------- Inductor ------------
| |
------ Capacitor -----
How can I model above device in XTK?
Thanks.
Best Regards.
Kal.
#########################################################
Kal Won Kwang
Assistant Engineer
E-CAE part Solution group
Engineering-Collaboration & Innovation Management Center
Corporate Technology Operations
Samsung Electronics Co., LTD.
phone: 82-31-200-3439, fax: 82-31-200-4692
email: [email protected]
#########################################################
**** To unsubscribe from si-list or si-list-digest: send e-mail to
[email protected]. In the BODY of message put: UNSUBSCRIBE
si-list or UNSUBSCRIBE si-list-digest, for more help, put HELP.
si-list archives are accessible at http://www.qsl.net/wb6tpu
****
**** To unsubscribe from si-list or si-list-digest: send e-mail to
[email protected]. In the BODY of message put: UNSUBSCRIBE
si-list or UNSUBSCRIBE si-list-digest, for more help, put HELP.
si-list archives are accessible at http://www.qsl.net/wb6tpu
****
This archive was generated by hypermail 2b29 : Thu Jun 21 2001 - 10:11:48 PDT