Do It Yourself
28V to 50V 15A DC Power Supply
The 50MHz magic band will be on peak propagation at the last and this years. I am now currently use the homemade dipole and FT-736 + homemade 100W linear amplifier for the DX. Because of my dipole antenna is no gain, I feel that I always can listen the DX stations but cannot call back them at the same time. In this cause, I think I need to build a new higher power linear amplifier. In this project, the 50V 15A DC power supply. I want to use it to drive my 50MHz 300W amp. And also the Phase 3D satellite is ready now. So I also need to increase my 430MHz TX power from 25W to 100W. That 430MHz linear amplifier use 28V DC operate. For the 50V 15A power supply, I am now make it from at least 28V to 50V. Please see the following information.
¡@
¡@
¡@
¡@
¡@
¡@
Schematic Diagram in PDF
format
The accident happened
during the test
¡@
Specifications and Details :
| a)
¡@ |
Input
Voltage
¡@ |
:
¡@ |
220V
AC
¡@ |
| b)
¡@ |
Output
Voltage
¡@ |
:
¡@ |
28V
to 50V DC
¡@ |
| c)
¡@ |
Max.
Output Current
¡@ |
:
¡@ |
15A
¡@ |
| d)
¡@ |
Output
Voltage Adjust
¡@ |
:
¡@ |
With
a variable resistor from 3V to 50V any voltage adjust.
¡@ |
| e)
¡@ |
Output
Terminal
¡@ |
:
¡@ |
With
two pairs Red and Black output terminals.
¡@ |
| f)
¡@ |
Circuit
Protection
¡@ |
:
¡@ |
With
4 pcs of fuse at primary part and current limiter at 15A maximum output.
¡@ |
| g)
¡@ |
Filtering
Device
¡@ |
:
¡@ |
35V
4700uF x 20pcs Electrode Capacitor.
¡@ |
| h)
¡@ |
Regulated
Device
¡@ |
:
¡@ |
4 pcs of 120V 30A 250W darlington power transistors, 4 pcs of middle power transistors, 2 pcs of small signal transistors and 2 pcs of zener diodes.¡@ |
| i)
¡@ |
Transformer
Device
¡@ |
:
¡@ |
With
2 pcs of 21V-0-21V 300VA power transformer.
¡@ |
| j)
¡@ |
Display
Unit
¡@ |
:
¡@ |
With
large size voltage, current meter and back lights.
¡@ |