+++++++++++++++ See also Resistance Checks +++++++++++++++ Date: Mon, 02 Dec 2002 10:50:15 -0800 From: Wayne Burdick Organization: Elecraft To: Denis Dimick Cc: "Michael S. Hunt" , elecraft at mailman.qth.net Subject: [Elecraft] Re: K1 Resistance Checks The nominal resistance from pins 2 and 3 of an LM386 to ground is 150 k, but this apparently varies considerably from one lot to the next. The resistance chart will be changed to "less than 250 k" to accomodate process variations. A higher input resistance here will not affect performance. 73, Wayne N6KR Denis Dimick wrote: > > I think mine was the same, and my K1 works fine.. > > Denis - KC6AUP > > On Sat, 30 Nov 2002, Michael S. Hunt wrote: > > > On page 29 of the K1 manual is a list of resistance checks for the RF > > board. All of my values check out except one. I have completely > > checked all of the parts on the RF board for placement and value twice > > and everything is correct. All of the solder joints look clean. > > > > U3 pin 3 207K this should be < 200K +++++++++++++++