Next Up Previous Contents Index
Making a Diskette Under MS-DOS

B.1 Making a Diskette Under MS-DOS

To make a diskette under MS-DOS, use the rawrite utility included on the Red Hat Linux CD in the dosutils directory. First, label a blank, formatted 3.5-inch diskette appropriately (eg. ``Boot Diskette'', ``Supplemental Diskette'', etc). Insert it into the diskette drive. Then, use the following commands (assuming your CD is drive d:):


C:\> d:
D:\> cd \dosutils
D:\dosutils> rawrite
Enter disk image source file name: ..\images\boot.img
Enter target diskette drive: a:
Please insert a formatted diskette into drive A: and
press --ENTER-- : [Enter]
D:\dosutils>

rawrite first asks you for the filename of a diskette image; enter the directory and name of the image you wish to write (for example, ..\images\boot.img). Then rawrite asks for a diskette drive to write the image to; enter a:. Finally, rawrite asks for confirmation that a formatted diskette is in the drive you've selected. After pressing [Enter] to confirm, rawrite copies the image file onto the diskette. If you need to make another diskette, label another diskette, and run rawrite again, specifying the appropriate image file.


Next Up Previous Contents Index