The GeminiG3 serial ports can be logically connected to local and remote services to aid in configuration and troubleshooting, or they can be connected to a remote Host application or even to the serial port of a remote unit.
Independent check boxes to activate DEV-1 PORT and/or DEV-2 PORT
Select 300, 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200 Baud Rate.
Default is 115200 for DEV-1 port and 9600 for DEV-2 port.
Number of bits making up the data word. Set according to Host configuration. Default is 8.
Marks the end of the serial port data byte. Default is 1
Added to identify the sum of bits as odd or even. Default is None.
Select None or CTS-based (RTU dependent)
Select Permanent (3-wire) or Switched (DTR bringup/teardown) (RTU dependent)
Select one of:
CLI Service (Command line interface) RS-232 connection to Host PC
GPS - Direct GPS reports (see GPS → Delivery) to this serial port
Custom - Choosing Custom enables the IP Gateway Transport configuration
Default is CLI Service for DEV-1 port and GPS for DEV-2 port.
Available only if IP Gateway Service selection is Custom. Choose the socket connection mode from the drop-down list box choices of TCP Server, TCP Client, or UDP.
Valid unicast or multicast IP address, including the local Loopback interface address. Default local IP address is set to 0.0.0.0 and can be changed dynamically without a unit reset.
For TCP Client and UDP socket connections, set to any value between 1 and 65535.
For TCP Server socket connections, set to any value between 1 and 65535 but must not be set to one of the following values or fall within the following ranges of values: 20, 21, 23, 123, 520, 5002, 6254 to 6299, 7000 to 7100. Otherwise, the parameter configuration will be accepted, but no socket connection will be established to accept connection from remote endpoints.
Default local port value is set to 1024 and can be changed dynamically without a unit reset.
Default remote IP address is the Loopback interface address, 127.0.0.1 and can be changed dynamically without a unit reset
For all socket connection modes (TCP passive, TCP active, UDP), set to any value between 1 and 65535.
Default local port value is 23 and can be changed dynamically.
Can be UP, READY, or DOWN. Click on the "Refresh" word in the (Refresh this frame to confirm "Status") sentence to update Status condition.