Setup (Advanced) → RF (Freq.)

Each Gemini G3 is provided with 32 internally stored over-the-air programmable channels.
Use the table below to set up RX and TX frequencies for each channel .

Radio Table Set Up

Enter RX and TX frequency in MHz in the appropriate dialog box.
Entries in the RX column must fall within the Min RX and Max RX indicated on top of the page.
Entries in the TX column are computed as RX frequency plus the offset indicated on top of the page.

E.g.:

Assuming:
Min Rx=851.000 000 MHz
Max Rx=869.000 000 MHz
Offset=-45.000 000 Mhz

If selection for a channel's RX was:
Rx (MHz)=853.037 500
then its corresponding TX would be computed as:
Tx (MHz)=853.037 500+(-45.000 000)=808.037 500

Bandwidth

"BW" entries for all channels can be :

"W" (Wide - 700MHz), "F" (Full - UHF or 800MHz), "H" (Half - UHF or 700MHz), or "N" (NPSPAC) - 800MHz) as appropriate.

Output Power Limiting

Limit Power to:

100% - Sets Output Power to its maximum of 27W (700MHz) or 35W (800 MHz)
75% - Sets Output Power to 75% of its maximum
50% - Sets Output Power to 50% of its maximum
10 Watts - Sets Output Power to that value