Nice stuff for sale.  Make me an offer via email at [email protected] or call 262-376-5388

DX Engineering 80m 4-square controller.  Bought it used a while back when I thought I could squeeze the antennas on to the lot.  You can also use it to feed dipole elements hung from a tower or just a pair of verticals. No docs but it's not hard to figure out how to set it up. 

Custom made 8x2 antenna switch for SO2R.  Can select any one of 8 antenna ports for either of two radios.  Tested to 1.5KW and 30MHz. Works great!  I used the same relays as found in the DX Engineering controller above and their antenna switches.  Built on a double-sided board with SO-239 connectors and steel box.  You supply +12VDC to operate - CAT 5 cable works great for this. There is a positive lockout so you can't put both radios on the same antenna [in addition, the Sonalert on the box tells you that you're trying to do this - will keep you awake in the last few hours of the contest ;-) ].   I'm selling it because I ran two copies of the board and don't need two of them.   Similar in many ways to the well known 6-pack from Array Solutions. 

MFJ-962C tuner and coax switch.  Tapped inductor. Works great. The only issues are that the 12V bulbs for the meter are burned out (easy fix) and (as you can see in the photo) the paint on the panel is worn off behind the antenna selector switch.   It lets you select between 2 coax feedlines direct or through the tuner, a third coax feedline direct only, and a balanced line.  This box served me well for several years but it's been sitting on the shelf for a while - don't need it. 

Henry 1000D 220MHz Amplifier

W6PO - style RF deck.  Factory setup for 210-240MHz.   Runs a single 8877.

Big B+ supply.  1200W output with 20W drive. More if needed ;-)