KENWOOD TMV-7 OPERATION

Revision 1.1 03/19/2000



    1. Power Switch – OFF(Push & hold for ½second)
    2. PM Switch - Danger!
    3. MNU Switch – Push to access MENU – Danger!
    4. Right Side Volume & Band Select
    5. Right Side squelch
    6. Control Select – Danger!
    7. Left Side Volume & Band Select
    8. Left Side squelch
    9. Power Level Switch – (Low, Medium, High) Per Side
  10. Rev Switch – Push to listen on repeater input
  11. Tone Switch – Push to enable PL tone – Danger!
  12. Function Switch – Danger!
  13. Tuning Knob – Push for MHz only
  14. Memory Select – Danger!
  15. VFO Select – Danger!
  16. Call Switch
  17. Lock Switch on back of microphone. Set to LOCK

This procedure describes basic operation for LCARPSC SKYWARN operation only.
The Left Side is normally set to 145.760 SIMPLEX DATA MODE
The Right Side is normally set to 442.150 +OFFSET (K8DTX MICON)

  1. Press Power Switch #1 to turn on radio.
  2. Press the Left Side Volume & Band Select #7
  3. Press the Memory Select #14 quickly! Do not hold!
  4. Rotate the Tuning Knob #13 until the 145.760 frequency is visible.
  5. Press the Right Side Volume & Band Select #4
  6. Press the Memory Select #14 quickly! Do not hold!
If the Right Side shows 2 meter frequency’s instead of 70cm frequency’s do the following steps:
Do not pause between these three steps.
a)    Press the Function Switch #12 quickly.
b)    Press the Control Select quickly.
c)    Press the Memory Select #14 quickly! Do not hold!
70cm frequencies should now be displayed on the right side.
  1. Rotate the Tuning Knob #13 until the 442.150 frequency is visible.
  2. Press the MNU Switch #3 quickly!
  3. Rotate the Tuning Knob #13 until "Data Transfer 15" is visible.
  4. A small arrow pointing right will be above the button Rev Switch #10. Press it once.
  5. The word "set" will appear above the Power Level Switch #9. Press it once or twice until the display reads "DATA BAND ON"
  6. Press the MNU Switch #3 quickly!
The radio is now ready for operation for both Digital & MICON modes.

Turn off the radio by pressing and holding the Power Switch #1 for ½ second.

Home