2.3.0 PROGRAM INSTALLATION
In most cases all required programs will come preinstalled on the computers hard drive and will be ready for use. This document is provided in case the user finds it necessary to reload the code after a catastrophic system failure.
Disconnect Power from Servo Controller until system is fully programmed!
If Servo controller is turned on before program loading is finished the
Bellows will slam because servo parameters have not been programmed!
Insert Disk 1 of 2 - Phoenix Multisystem V1.0
Press Start on bottom menu bar
Open: Should read: A:\setup.exe (otherwise, type this command in)
Phoenix Multisystem Installation should start up.
Phoenix Multisystem Directory should read: C:\Phoenix_Dual(Do not change this!)
At the prompt, insert Disk 2 and press OK
At the prompt, "Phoenix Multisystem Installation Successful", press OK
Program will finish and a box with the Phoenix 2 icon will appear.