2.1.1.7 Sequence names control (marker #7 of image 2.1.1)
This control allows the selection of one of the 12 preset profiles
When a preset button is depress it turns red indicating it is the active button
and it changes the system settings to the presets stored on the hard drive
Note: In order to use the setting it must contain a name and have been set with data.
(having no buttons depressed puts the system into the console mode (also referred to as the manual mode)
When a preset button is depressed there appears a square white block to its immediate right
(not shown)depressing this block creates a empty name box. Enter a name into the box (it is
suggested that the name is descriptive of the task or settings but may be anything the operator desires.) depressing the enter key then sets the name into the Sequence file so whenever that Sequence file name is selected (see above SEQUENCE FILE) the sequence names will appear below in the SEQUENCE NAMES area. In order to use the newly named button, system data must be saved into that particular button see 2.1.1.2