2.1.0.1 VIRTUAL "FRONT PANEL” OPERATORS’ CONTROLS AND INDICATORS
11a-11b. Altitude compensation
AMBIENT PRESSURE (mmHg) - Allows the operator to set the pressure at which the Machine
case will be operating.(default is 760.00 mmHg based on 0 ft altitude 1976 U.S. Standard Atmosphere)
AMBIENT TEMP (Kelvin) - Allows the operator to set the temperature at which the machine
case will be operating. .(default is 288.15 Kelvin based on 0 ft altitude 1976 U.S. Standard Atmosphere)
12.COMMIT - Depressing this button loads the current front panel information into memory
When the operator has elected to have to units active then it is possible to synchronize the to units using unit 1 as a reference.
DELAY - The operator can set unit 2 to delay its start until after unit 1 has performed x number of breath cycles.
PHASE - The operator may offset unit 2 to begin its start after x number of data points have occurred in unit 1 cycle i.e.. ( if unit 1 has a total of 100 points per full cycle then setting phase to 50 will cause unit 2 to begin its cycle 180 degrees out of phase with unit 1)
Note: If phase is larger than total number of points per cycle of unit 1 then the phase will be equal to setting a delay of phase/points per cycle with the remainder being the phase offset.
both Delay and Phase can be used simultaneously.
14. RUN/STOP Button - Activates/de-activates profile run.
15. STATUS Window - Informs operator of the current status of the CVPBS, including errors.