Revised 08/18/2000 |
CERT Comm, Fremont, CA. |
To: |
Do the following |
Turn the radio on |
Press the POWER key |
Adjust the volume |
Repeated press the UP or DOWN keys |
Adjust the squelch |
While holding the FUNCTION button, repeatedly press either the UP or DOWN keys. |
Set the frequency |
|
Change to Simplex |
If a + or – is displayed, hold the FUNCTION button and press the 2 key until they disappear. |
Set offset for repeater (duplex) operation |
|
Set tone encode (PL) |
|
Change power |
Press and hold the FUNCTION button, then press the LAMP H/L key. An L is displayed when the radio is set to low power. |
To: |
Do the following |
Recall a pre-programmed frequency |
|
Store settings in memory |
|
Standard CERT Channels
The following frequencies should be stored in the memory of CERT radios
CHNL |
Frequency (MHz) and offset |
PL Tone (Hz) |
Remarks |
1 |
147.015 + |
103.5 |
Resource Repeater |
2 |
147.015 |
Repeater output frequency. Use when repeater is fails. |
|
3 |
146.940 - |
123.0 |
Tactical Repeater. (Primary channel for CERT out-of-district communications). |
4 |
146.940 |
Repeater output frequency. Use when repeater is fails. |
|
5 |
145.700 |
ARES simplex frequency. |
|
6 |
145.030 |
Packet |
|
7 |
146.505 |
CERT Simplex #1 (Use for in-district communications.) |
|
8 |
147.450 |
CERT Simplex #2 (Use for in-district communications.) |
|
9 |
146.520 |
National Simplex Calling Frequency |
|
10 |
162.550 |
Weather, Emergency Alerts |