FT-411 OUT OF BAND MODIFICATIONS

 1) Open the front cover
 2) Locate the C.P.U. unit (it is located on the front cover ).
 3) Locate Jumpers 1,2,3 and 4 , These are the band setting Jumpers
 4) Jumpers No 1,2 and 4 should be disconnected ,and Jumper No 3 should
    be connected.
 5) Close the radio .
 6) Apply power to the radio and turn it on.
    The display will initialize with memory No 1 flashing and the
    frequency display will show 1.000
 7) Now , adjust the display to the desired lowest receive frequency
    When done ,press VFO.
    The memory CH will now show 2 flashing .
 8) Adjust the display to the desired highest receive frequency
    When done press VFO .
    The memory CH will now show 3 flashing .
 9) Adjust the display to the desired lowest transmit frequency
    When done ,press VFO.
    The memory CH will now show 4 flashing .
10) Now , adjust the display to the desired highest transmit frequency
    When done ,press VFO.
11) The rig is now set for your programed band on transmit and receive.