This beam was developed from a design by WB2HOL and found at
http://home.att.net/~jleggio/projects/rdf/tape_bm.htm
This beam was constructed per the instructions on WB2HOL's web site with the following exceptions:
1. | The PVC was first cleaned and then glued. | |
2. | A hole was cut into the boom near the reflector to allow the coax to be run through the boom and the handle. | |
3. | A small piece of PVC was added to the reflector end of the boom and a 90 degree elbow and a 6-inch piece of PVC was added to act as a "pistol type" handle. | |
4. | A 5-inch piece of 12 gauge "romex" was used for the hairpin. | |
5. | RG-8X (mini-8) coax was used. |
(For better detail, click on a image for a 640 x 480 pixel image)