TH-G71A MODIFICATIONS
                            ---------------------

                       MARS/CAP MODIFICATION INFORMATION
                       ---------------------------------
It is illegal to operate outside the limits of your class license or permits.

Modification procedure:
 1. Remove the battery pack and antenna.
 2. Open the SPKR/MIC dust cover,
 3. Remove the three screws from the back panel ofthe transceiver.
 4. CarefuIly lift up the bottom end of the back panel and pull the entire
    back pane I toward the bottom ofthe transceiver to clear the antenna
    connector from the top panel. Do not break the ribbon cable that
    connects the back panel PCB to the front case PCB.
 5. Set the back panel to the left side of the front case.
 6. At the bottom right side ofthe front case PCB you will see a green
    jumper wire.Cut this wire using a sharp pair of wire cutters. Be careful
    not to pull on the wire, simply cut it in half.
 7. Assemble the transceiver by reversing the steps listed above. The
    transceiver will automatically reset when turned on,

Transmit Operating Range: 142.000MHz - 151.995MHz, 420.000MHz - 449.995MHz


                      BEYOND MARS MODIFICATION
                      ------------------------

 Modification procedure:
 1. Remove the battery pack and antenna.
 2. Open the SPKR/MIC dust cover.
 3. Remove the three screws from the back panel ofthe transceiver.
 4. Carefully lift up the bottom end of the back panel and pull the
    entire back panel toward the bottom of the transceiver to clear
    the antenna connector from the top panel. Do not break the ribbon
    cable that connects the back panel PCB to the front case PCB.
 5. Set the back panel to the left side of the front case.
 6. Locate and remove diodes D512 and D513 from the bottom right side
    of the front case PCB. If the green jumper wire has been cut,
    reconnect it at this time.
7.  Assemble the transceiver by reversing the steps listed above.
    The transceiver will automatically reset when turned on.

Transmit Operating Range: 136.000MHz-173.995MHz, 400.000MHz- 469.995MHz,
Additional RX Capability: 320.000MHz- 399.99375MHz, 800.000MHz- 823.9875MHz,
                          849.000MHz- 868.9875MHz, 894.000MHz- 949.9875MHz

NOTE: This change also allows the transceiver to access a previously
      suppressed menu, number 16. This menu allows the transceiver to
      switch between FM and AM in the 118MHz - 136.000MHz range.


                    EXTENDED RECEIVER MODIFICATION
                    ------------------------------

Modification procedure:
1. Remove the battery pack and antenna.
2. Open the SPKR/MIC dust cover.
3. Remove the three screws from the back panel ofthe transceiver.
4. Carefully lift up the bottom end ofthe back panel and pull the entire
   back panel toward the bottom of the transceiver to clear the antenna
   connector from the top panel. Do not break the ribbon cable that connects
   the back panel PCB to the front case PCB.
5. Set the back panel to the left side of the front case.
6. Locate and remove diode D512 from the bottom right side of the front
   case PCB.
7. Assemble the transceiver by reversing the steps listed above. The
   transceiver will automatically  reset when turned on.

  RX Capability: 136.000MHz - 173.995MHz, 400.000MHr - 469.995MHz,
                 320.000MHz - 399.9937SMHz, 800.000MHz - 823.9875MHz,
                 849.000MHz - 868.9875MHz, 894.000MHz- 949.9875MHz

NOTE: This change also allows the transceiver to access a previously
      suppressed menu, number 16. This menu allows the transceiver
      to switch between FM and AM in the 118MHz - 136.000MHz range.