GB3PD 6M Repeater Data


Status
  • Date of service: 28-March-1998
  • Keeper: Andy, G4JXL
  • Information last updated: 29 March 1998
  • Coverage: See high resolution map

    Location
  • IARU Locator: IO90KT

    Antenna Configuration
  • Antenna: Vertical Dipole ( 0 dBd gain)
  • Single Antenna working used
  • Radiation: Omnidirectional

    Repeater Equipment
  • Transmitter: Tait T336/05
  • Output Power: 10 dBW ERP
  • Receiver: Tait T335/05
  • Sensitivity: 0.2 uV / 12 dB SINAD
  • (measured at duplexer common port; transmitter running @ 20 W output)
  • Logic: G0RDI
  • Duplexer: Homebrew by G4JXL/G4NAO, to WB5WPA design.
  • RX isolated by 75 dB from TX,
  • TX isolatedby 74 dB from RX

    Frequencies & Access Control
  • Input (repeater receiver) frequency: 51.350 MHz
  • Output (repeater transmitter) frequency: 50.850 MHz
  • Access by CTCSS 71.9 Hz (UK tone "B") at peak deviation 250 Hz
  • Continuous CTCSS tone needed for talk-through.

    Controller Characteristics
  • G0RDI. See GB3AM Data Sheet for full details.


    Places to go from here:
    Back to the GB3AM Home Page; Latest available information about UK 6M repeaters from my update page; Some pictures taken on site at GB3AM; An insight into the hardware in use at GB3AM; the history of GB3AM.

    Disclaimer: This page is the way it is. There's nothing you can do about it.

    Webmaster: Iain Philipps - G0RDI

    Note: This page is Copyright (c) 1997, 1998 Iain Philipps. If you must copy information from it, you are free to do so PROVIDED you acknowledge the source. A much better thing to do is provide a link to it!

    Last updated:- 29 March 1998